MacDon M200 Manuel de l'opérateur télécharger pdf (Page 165)

MAINTENANCE AND SERVICING - M200 ENGINE

Form 169017 / 169087 / 169095 163 Revision C

e. Change secondary filter (D) as follows:

1. Thoroughly clean around the filter head (L).

2. Remove filter (D) with a filter wrench, and

safely dispose of the filter.

3. Lubricate O-ring seal with clean engine oil.

Do not fill canister with fuel before canister is

installed.

4. Screw the new filter (D) onto the filter mount

until the gasket contacts the filter head.

5. Tighten the filter an additional ½ to ¾ turn by

hand.

IMPORTANT

Do not use a filter wrench to install the filter.

Over-tightening can damage the gasket and

filter.

f. Open fuel valve (E) under fuel tank.

g. Push the priming pump (M) until glass bowl is full,

and resistance is felt on the pump. If engine does

not start, repeat this procedure.

h. Close engine compartment hood.

i. Remove the container, and dispose of the fluid in

a safe place.

7.9.6.3 Separator

A fuel water separator is incorporated into the

primary fuel filter. Drain the water and sediment

as follows from the separator daily.

DANGER

Stop engine and remove key from ignition

before leaving Operator’s seat for any reason.

A child or even a pet could engage an idling

machine.

a. Stop engine, and remove key.

b. Place a suitable container under primary filter.

Install a suitable tube onto the water separator

drain (B).

c. Turn drain valve (B) by hand 1½ to 2 turns counter

clockwise, and allow fluid to drain into the

container.

d. Drain the filter sump of water and sediment until

clear fuel is visible in glass bowl.

e. Turn the valve clockwise to close the drain.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 233 234

Commentaires sur ces manuels

Pas de commentaire

MacDon M200 Manuel de l'opérateur Page 165

Commentaires sur ces manuels

Produits connexes et manuels pour Tracteur MacDon M200