MacDon M200 Manuel de l'opérateur Page 141

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 234
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 140
MAINTENANCE AND SERVICING - M150 ENGINE
Form 169017 / 169087 / 169095 139 Revision C
7.8.5 AIR INTAKE SYSTEM
IMPORTANT
Do not run engine with air cleaner
disconnected or disassembled.
Engine intake air (A) is drawn through a duct (B)
from the cooling box that pre-cleans the air, and
then through a dual element filter (C).
The air cleaner canister is equipped with a
vacuator valve (D) that removes dust continuously
from the air cleaner housing.
The air cleaner is also equipped with a restriction
switch (E) which activates a warning light on the
CDM with an alarm when the primary filter
element requires cleaning.
NOTE
The warning light could activate when
operating in extremely dirty conditions, in
which case the filter element should be
cleaned. Under normal operating
conditions, filter servicing should be
performed at the specified interval. Refer to
Section 7.14 MAINTENANCE SCHEDULE.
7.8.5.1 Air Filter Servicing
DANGER
Stop engine and remove key from ignition
before leaving Operator’s seat for any reason.
A child or even a pet could engage an idling
machine.
a. Open engine compartment hood to highest
position.
b. Lift catch (G) on top of cap, and rotate end cap (F)
counter clockwise until it stops, and arrow (H)
lines up with unlock symbol on end cap. Pull off
the end cap.
c. Check the vacuator valve (D) daily for obstructions
or damage. Clean or replace if necessary.
d. Pull out the primary filter element (J), and inspect
as follows:
(continued next page)
E
D
C
B
A
J
F
G
H
D
Vue de la page 140
1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 233 234

Commentaires sur ces manuels

Pas de commentaire