MacDon M200 Manuel de l'opérateur télécharger pdf (Page 138)

MAINTENANCE AND SERVICING - M150 ENGINE

Form 169017 / 169087 / 169095 136 Revision C

e. Clean area around the plastic cap on access hole

(B). Remove the cap.

f. Insert the tool (C) into the flywheel housing until it

engages the ring gear.

g. Attach a 1/2 inch square drive ratchet or breaker

bar and turn.

h. Remove barring tool, and clean oil from around

access hole.

i. Clean plastic cap, and reinstall in hole with

silicone sealant.

j. Reconnect the battery.

k. Close hood, and move maintenance platform back

to working position.

7.8.3 OIL LEVEL

Check engine oil level frequently, and watch for

any signs of leakage.

NOTE

During the break-in period, a higher than

usual oil consumption should be considered

normal.

Check the oil level as follows:

a. Stop the engine, and remove the key. Wait about

5 minutes.

b. Open engine compartment hood to lowest

position.

c. Remove dipstick by turning it counter clockwise to

unlock and remove.

d. Wipe clean, reinsert in engine and remove.

e. Oil level should be between LOW and HIGH

marks.

f. Replace dipstick.

(continued next page)

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 233 234

Pas de commentaire

MacDon M200 Manuel de l'opérateur Page 138