MacDon M200 Manuel de l'opérateur télécharger pdf (Page 146)

MAINTENANCE AND SERVICING - M150 ENGINE

Form 169017 / 169087 / 169095 144 Revision C

d. Change secondary filter (D) as follows:

1. Clean around the filter head.

2. Place a container under the filter to catch

spilled fluid.

3. Remove filter (D) with a filter wrench.

4. Clean gasket mating surface.

IMPORTANT

Do not pre-fill filter with fuel. Pre-filling can

contaminate the fuel system.

5. Screw the new filter onto the filter mount until

the gasket contacts the filter head.

6. Tighten the filter an additional ½ to ¾ turn by

hand.

IMPORTANT

Do not use a filter wrench to install the filter.

Over-tightening can damage the gasket and

filter.

e. Open fuel valve (E) under fuel tank.

f. Prime the system. Refer to Section 7.8.6.5

System Priming.

g. Close engine compartment hood.

7.8.6.3 Draining Fuel Tank

Draining the fuel tank is necessary to remove old

or contaminated fuel.

To drain the tank refer to following illustrations and

proceed as follows:

a. Stop the engine and remove the key.

b. Open engine compartment hood to lowest

position.

c. Close fuel supply valve (E).

d. Place a drain pan of about 5 U.S. gallons (20

litres) under the fuel supply line (J).

e. Loosen clamp (K), and pull hose (J) off fitting.

f. Route hose to drain pan and open valve (E) to

drain tank.

(continued next page)

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 233 234

Pas de commentaire

MacDon M200 Manuel de l'opérateur Page 146