MacDon M200 Manuel de l'opérateur télécharger pdf (Page 73)

WINDROWER OPERATION

Form 169017 / 169087 / 169095 71 Revision C

k. Make the electrical connections (J) at the header

wheel, and at the joint (K).

l. Attach weight box to windrower lift arm linkage as

follows:

IMPORTANT

To prevent damage to the lift system when

lowering header lift linkages without a

header or weight box attached to

windrower, ensure that float engagement

pin is installed in storage location (C), and

not installed at hole location (B).

1. Drive windrower so that windrower lift arms

are positioned into the weight box pockets.

2. Raise lift arms slightly and install locking pins

(D) into pockets and through windrower

header lift linkages. Secure with hairpin.

NOTE

Pins (D) were previously removed from the

header lift linkage lower end.

3. Route the weight box harness (O) to the

electrical connector at the left side lift linkage,

and connect harness to connector.

m. Raise lift arms, and move float pins from storage

location (C) to engaged position (B).

(continued next page)

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 233 234

Pas de commentaire

MacDon M200 Manuel de l'opérateur Page 73