MacDon M200 Manuel de l'opérateur télécharger pdf (Page 110)

HEADER OPERATION - A SERIES

Form 169017 / 169087 / 169095 108 Revision C

6.6.5 KNIFE SPEED

The ideal cutting speed of the knife should be

such that a clean cut is achieved. Crop types and

conditions usually influence the knife and forward

speeds.

The Windrower Control Module (WCM) reads a

code from the header that determines the knife

speed range and the minimum speed when the

header is first attached to the windrower.

The desired speed can be programmed on the

CDM, and is stored in the WCM memory so that if

the header is detached and then re-attached to

the windrower, the knife will operate at the original

set-point.

If no header code is detected, the CDM displays

NO HEADER and the knife speed reverts to a

range from 0 - 1400 strokes per minute and the

operator can then pre-set the speed.

HEADER

DESCRIPTION

KNIFE SPEED *

(Strokes Per Minute

[SPM])

TYPE SIZE MINIMUM MAXIMUM

Auger A40 All 1400 1950

Auger A30S All 1250 1550

Auger A30D All 1550 1850

* Suggested Overload Setting - 75% of Knife Speed.

NOTE

The knife speed cannot be programmed

outside the range specified for each header.

NOTE

The speed can be adjusted without shutting

down the machine, although it is

recommended that the windrower be

stopped to enable the operator to re-

program the WCM.

Display and set knife speed “on-the go” as follows:

CAUTION

Check to be sure all bystanders have cleared

the area.

DISPLAY

SLOWER

FASTER

PROGRAM / SELECT

PRESS

PROGRAM/SELECT

DISPLAY SHOWS

#### KNIFE SPM

DONE

SPEED

O.K.?

YES

ON CDM PRESS

LEFT ARROW o

RIGHT ARROW

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 233 234

Commentaires sur ces manuels

Pas de commentaire

MacDon M200 Manuel de l'opérateur Page 110

Commentaires sur ces manuels

Produits connexes et manuels pour Tracteur MacDon M200