MacDon M200 Manuel de l'opérateur télécharger pdf (Page 104)

HEADER OPERATION - A SERIES

Form 169017 / 169087 / 169095 102 Revision C

d. Connect center-link as follows:

MECHANICAL LINK - M150

1. Loosen nut (F), and rotate barrel (G), to adjust

length so that other end lines up with header

bracket.

2. Install pin (H), and secure with cotter pins.

3. Adjust link to required length for proper

header angle by rotating barrel (G). Tighten

nut (F) against barrel. A slight tap with a

hammer is sufficient.

4. Proceed to step e.

HYDRAULIC LINK WITHOUT SELF-ALIGNMENT

KIT - M200 STD, M150 OPTION

1. Relocate the pin at the frame linkage as

required to position the hook over the header

pin.

2. Activate HEADER TILT cylinder switches on

GSL to extend or retract center-link cylinder

so that the hook lines up with the header

attachment pin.

3. Push down on rod end of link cylinder until

hook engages pin on header and is locked.

4. Check that center-link is locked onto header

by pulling upward on rod end of cylinder.

HYDRAULIC LINK WITH OPTIONAL SELF-

ALIGNMENT KIT

1. Adjust the position of the center-link cylinder

with the REEL UP and REEL DOWN

switches, and HEADER TILT switches on the

GSL to position the hook above the header

attachment pin.

2. Lower the center-link onto the header with

REEL DOWN switch, until it locks into position

(handle is down).

(continued next page)

HEADER TILT UP

HEADER

TILT DOWN

REEL UP

REEL DOWN

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 233 234

Pas de commentaire

MacDon M200 Manuel de l'opérateur Page 104