Macdon 742 HAY CONDITIONER Manuel d'utilisateur télécharger pdf (Page 17)

Form # 46290 Issue 09/05

OPERATION

ATTACHING THE HAY CONDITIONER (continued)

8. Raise header fully. Stop engine, remove key

and engage header lift cylinder stops.

9. Place a 2 x 4 under the R/H conditioner shoe

as shown at (G). (No block under left side.)

10. Remove header lift cylinder stops and lower

conditioner onto block. Shut off engine and

remove key.

11. Use the following steps for the appropriate

tractor model:

For 52 Series tractors (24 inch rims only):

NOTE: For tractors prior to 52 Series (16 inch

rims), see next page.

• Install conditioner lift link (J) at R/H side

as shown.

• Install clevis to secure upper end of

adjustable link to lift linkage pin and

secure to lower end to chain at R/H

conditioner mount.

• Install bolt (M) through chain at R/H

conditioner mount.

• Install clevis, lock washer (K) & lynch pin

(L) to secure upper end of chain to lift

linkage pin.

• With cutterbar set at desired cutting

height, adjust turnbuckle link length to 1-

1/2 to 2 inch ground clearance to

conditioner shoe. Secure jam nut on

turnbuckle link.

NOTE: Turnbuckle adjuster pin (N) (shipped

with hay conditioner) can be stored in tractor

floor board as shown.

NOTE: May need to cut chain down to three

links for slightly higher conditioner clearance.

BLOCK UNDER R/H SHOE

TURNBUCKLE ADJUSTER PIN STORAGE

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 123 124

Pas de commentaire

Macdon 742 HAY CONDITIONER Manuel d'utilisateur Page 17