Macdon D65 Combine Header Quick Card Manuel d'utilisateur télécharger pdf

1. Park combine on a level surface. Ensure that the combine feeder-

house is level.

2. Adjust header so cutterbar is 8-12 inches (200–300 mm) off the

ground.

3. Set guard angle to mid-position (between B and C on the indicator).

4. Set the reel fore-aft to mid-position (5 or 6 on reel arm decal).

5. Lower reel completely. Shut down the combine.

6. Place header float locks in un locked (lowered) position.

7. If equipped, set stabilizer/transport wheels to the fully raised position.

STEP 1: PRE-ADJUSTMENTS

Complete before adjusting FLOAT.

IMPORTANT

Be sure to have read your operator’s

manual, and complete all set-up tasks

before setting header float and wing

balance.

1. Remove the special torque wrench (A) from storage position on right

side of the CA25 combine adapter.

2. Place torque wrench (A) on the float lock at (B). Note change in orien-

tation of wrench between left and right side.

3. Push down on torque wrench (A) until bell crank (C) rotates forward.

4. Continue pushing down until indicator (D) on wrench reaches a MAXI-

MUM reading and begins to decrease. Note the maximum reading.

5. Repeat above steps for opposite side.

6. The readings should match the values in TABLE 1. HEADER FLOAT.

STEP 2: CHECK HEADER FLOAT

1. Refer to TABLE 1 for recommended initial float setting:

• If reading on wrench is high, header is heavy, so increase float.

• If reading on wrench is low, header is light, so decrease float.

2. Adjust header float to match values in TABLE 1. Turn each bolt pair

equal amounts.

• To increase float (lighter header), tighten (clockwise) float spring

bolts (A) and (B).

• To decrease float (heavier header), loosen (counter clockwise)

float spring bolts (A) and (B).

• Ensure wrench reading is EQUAL ON BOTH SIDES

NOTE

For 40 and 45 ft. double-knife headers, adjust float as

above, and then loosen RIGHT SIDE FLOAT spring

bolts (B) 2 turns.

STEP 3: SET HEADER FLOAT

Header Size

(ft.)

Torque Settings

Cutting on the

Ground

Cutting off the

Ground

30 and 35 1-1/2 to 2 2 to 2-1/2

40 and 45 2 to 2-1/2 2-1/2 to 3

TABLE 1. HEADER FLOAT

IMPORTANT

The torque settings in the above table are

recommended header float settings. Crop

and field conditions may require adjusting

the float to values outside these guidelines.

LEFT SIDE

RIGHT SIDE

1 2

Résumé du contenu

Page 1 - STEP 3: SET HEADER FLOAT

1. Park combine on a level surface. Ensure that the combine feeder-house is level. 2. Adjust header so cutterbar is 8-12 inches (200–300 mm) off th

Page 2

Divider RodsDraper Speed (Note 7)Header Angle (Notes 1 and 4) Knife Speed (Note 2)ReelCam SettingReel Speed % (Note 3)Reel Position Skid Shoe Positio

Commentaires sur ces manuels

Pas de commentaire

Macdon D65 Combine Header Quick Card Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel de jardinage Macdon D65 Combine Header Quick Card. MacDon D65 Combine Header Quick Card User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Macdon D65 Combine Header Quick Card