Macdon 742 HAY CONDITIONER Manuel d'utilisateur télécharger pdf (Page 16)

Form # 46290 Issue 09/05

OPERATION

ATTACHING THE HAY CONDITIONER

IMPORTANT: Before first use, prepare the header

and tractor for attachment of hay conditioner. See

Assembly section for instruction regarding installation

of tractor mounted brackets, drive pulley, etc.

1. Secure loose loop of belt towards rear of

conditioner as shown at (B).

2. Attach header to tractor. See Windrower Tractor or

Adapter Operator's Manual.

3. Raise header fully and drive slowly forward,

straddling conditioner, until mounting holes in

header leg are approximately in line with holes in

conditioner mounting arms. Lower header so

cutterbar is approximately 8 inches (200 mm) off

the ground.

4. Shut off engine and remove key.

5. Raise left conditioner mounting bar (A) and attach

to header leg with one 5/8 x 1-1/2 inch carriage

head bolt, lockwasher and nut. Repeat at right arm

(D).

6. Using a pry bar, raise front of conditioner and attach left support to left header leg at (E) with three 5/8 x 1-

1/4 inch carriage bolts, lockwashers and nuts. At top bolt, use the 20 mm (.78”) hole in header leg.

7. At right side, attach vertical support (F) to right header leg with one 5/8 x 1-1/2 carriage bolt, lockwasher

and nut.

STORE BELT FOR HOOK-UP CLEARANCE

ATTACH CONDITIONER TO HEADER

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 123 124

Pas de commentaire

Macdon 742 HAY CONDITIONER Manuel d'utilisateur Page 16